We won’t go through creating the TS from scratch in this post.įirst step is to check is the capture state task. Once the role has been installed we can start to create the task sequence to wipe and reload the device. we also need to set the boundary group that this state migration point will be associated with. Set the max free space in MB, GB or percentage. Open the MECM console and go to Administration > site configuration > server and site system roles and select or add the server that will be used as the state migration point Since the disk is going to be wiped and reformatted we wont be able to save the state to a local partition so we will need to use the state migration point to save content too.įirst step is to install and configure state migration point in MECM. We are using MECM 2002 and have installed ADK 1903 which has USMT version 10. It’s been a few years since I had to use USMT so thought it would be good to do a post on using USMT.įirst I went through the Microsoft USMT documentation. We needed to migrate the users data as to limit the manual work for each device so decided to use User State Migration Tool (USMT). We have been doing migration’s from some old Windows 8.1 devices to Windows 10, We couldn’t do a direct upgrade as the devices where going from 32 to 64bit and needed to reformat the disk to UEFI.
0 Comments
Leave a Reply. |